OBX Performance Ignition Wires

[1/17/2008] Reviewed by: Dustin Batchelor - dustinb@dbmiata.com

Applicable to: '90 - '97 1.6 liter 1.8 liter

This is a set of 10.33mm ignition wires. They are blue and use a hard plastic to surround the spark plugs.

I have had pretty good luck with OBX products, so I decided to order a set of these to replace some aging NGK blue wires. The first thing I noticed is that they are too long, and therefore don't fit well at all. Two of them wouldn't clip onto the spark plug until I removed the little rubber seal on the top. Because these cables are so thick, they will also not fit into the factory plastic wiring clips. After finally installing wires, I noticed an immediate decrease in engine responsiveness. When I went to remove them, it appeared then 2nd spark plug wire had unclipped itself.

All in all, these are horrible. I highly recommend you don't buy them.

Under 5 minutes to remove

Back to Product Reviews

14 February, 2008

[Home] - [FAQ] - [Search] - [Sponsors] - [Forums]
[Garage] - [Clubs] - [Contact Us] - [Disclosures] - [More...]
Copyright ©1994-2024, Eunos Communications LLC
All rights reserved.